Brilio.net - Many mobile phone users choose to use cases to protect their devices from dirt and scratches. Moreover, currently mobile phone cases are available in a variety of colors that can be adjusted to taste.
However, many also prefer clear cases because they still display the original design of the back of the phone. In addition, clear cases give a cleaner and more minimalist impression.
Unfortunately, over time, clear cases tend to change color to yellowish. If left unchecked, the color can darken to brown, making it look much different than when it was first used.
To overcome this, some people try to clean the casing using detergent solution. However, even after scrubbing for a long time, the yellow color that sticks is still difficult to remove.
To get around this, you can imitate what YouTube user Daris Sunandar Official did. In his video upload, this netizen appears to rely on two kitchen ingredients to whiten the cellphone casing.
As reported by brilio.net from YouTube Daris Sunandar Official on Wednesday (26/3), the kitchen ingredients used are dishwashing soap and salt . Both of these ingredients are dissolved in hot water in a bowl, yes.
"Stir until everything is mixed well," said the video owner.
photo: YouTube/Daris Sunandar Official
Once mixed perfectly, put the cellphone casing into the bowl. Press it gently so that the entire surface is completely submerged.
"Then we just leave it for about 10 to 15 minutes depending on the level of dirt," he said.
photo: YouTube/Daris Sunandar Official
The appearance of the cellphone casing appears to be clear again after being soaked for 15 minutes. To get maximum cleaning, this netizen then applied toothpaste to the entire surface of the cellphone casing.
"Once it's even, we soak it again in the water from before," he explained further.
photo: YouTube/Daris Sunandar Official
After the phone case is wet, scrub it briefly with an old toothbrush. Finally, rinse the phone case with clean water. Before use, dry it first with a cloth. The result is that the phone case is clean and clear again, right?
photo: YouTube/Daris Sunandar Official
How to install a cellphone case.1. Clean the cellphone first.
- Use a microfiber cloth or dry tissue to remove dust and dirt from the surface of the phone.
- If necessary, clean the back of the phone with a little alcohol or special cleaning fluid to make it cleaner.
2. Make sure the casing is clean.
- The casing should also be free of dust and dirt so that nothing gets trapped inside.
- If the casing is made of rubber or silicone, wash it with soapy water, then dry it before use.
3. Insert the cellphone into the casing correctly.
- The position of the cellphone must match the shape of the casing, make sure all buttons and ports are aligned with the holes.
- Start installing the casing from one side of the phone first, usually from the top or bottom.
4. Press gently until the casing is perfectly installed.
- Press the other side until the entire HP part enters the casing perfectly.
- Make sure the casing fits properly without any loose gaps.
5. Check the casing position again.
- Make sure all buttons, cameras, speakers, and charger ports are not covered by the case.
- Try pressing the power and volume buttons to make sure they are still working properly.
6. Tidy up any parts that don't fit properly.
- If there is a part of the casing that doesn't fit properly, press it gently until it fits the shape of the phone.
(brl/lut)
