Brilio.net - Motorcyclists are certainly very familiar with helmets as riding equipment. Helmets are the main safety devices that function to protect the head during road trips, so their use is mandatory when riding.
Unfortunately, many riders pay little attention to the cleanliness and maintenance of their helmets . In fact, helmets require regular maintenance just like the motorcycle itself. After a certain period of use, the quality and function of the helmet can decrease significantly.
Common problems occur when the helmet is often dropped or exposed to rain. Rainwater that is left to settle without being cleaned can cause the helmet visor hook to rust, causing the visor to become loose. As a result, the helmet visor will continue to fall down by itself when worn.
This condition is very disturbing to comfort and limits the driver's view while driving. Many people immediately decide to replace the helmet visor with a new one because they think the component is permanently damaged. But actually, there is a simple way that can be applied to overcome the problem of the helmet visor always going down.
For those of you who have similar problems, you don't need to rush to replace it with a new helmet. Because, there is an easy way that you can do to fix a loose helmet visor. The easy trick was shared by the TikTok account owner @67m4kans4t3.
Through his video upload, the man shared a trick to fix a loose helmet visor using only 1 used item. The used item is also quite easy to find around the house.
photo: TikTok/@67m4kans4t3
To make a loose helmet visor tight again, you only need to prepare a used motorcycle inner tube rubber that is no longer used. First, cut the inner tube rubber into a circle. After that, make a hole in the middle of the tire rubber so that it forms a donut shape.
photo: TikTok/@67m4kans4t3
Then open the helmet visor bolt, then attach the tire rubber to the helmet visor hook. Position the tire rubber according to the bolt hole on the helmet visor. The tire rubber can function as a replacement for the helmet visor hook that is damaged due to rust.
photo: TikTok/@67m4kans4t3
After the tire rubber is installed perfectly, reinstall the bolts on the helmet visor. Do the same steps on the other side of the helmet visor. As a result, the previously loose helmet visor can function normally again. The helmet visor can also be adjusted up and down. You also don't need to spend a lot of money to replace the helmet visor or a new helmet.
Another problem that occurs with helmet visors is usually scratches on the helmet visor. A helmet visor that is full of scratches can interfere with your view while driving and make the helmet look dull. But don't worry, there's no need to rush to replace it! With simple care and easy-to-find materials, you can reduce or even eliminate light scratches on the helmet visor. Check out the following tips:
1. Use non-gel toothpaste. Apply a thin layer to the scratched area, rub gently with a soft cloth in a circular motion, then wipe clean. Toothpaste helps smooth the glass surface.
2. Try using a scratch remover.
Use a special scratch remover product (usually for cars or motorbikes). Apply according to the instructions, the result can make the helmet glass look smoother.
3. Polish with a banana peel. Rub the inside of a banana peel on the helmet visor, then wipe with a microfiber cloth. The natural enzymes and oils in bananas can help disguise light scratches.
4. Clean regularly. Dust and fine sand can worsen scratches if the helmet glass is rarely cleaned. Use clean water and mild soap with a soft cloth regularly.
5. Avoid rough cloths when cleaning. Always use a microfiber cloth or other soft material. Wiping with a rough cloth can actually add new scratches.